This is a cache of https://www.uibk.ac.at/de/mechatronik/i-pel/forschung/offene-abschlussarbeiten/. It is a snapshot of the page at 2024-11-24T21:41:39.327+0100.
offene Abschlussarbeiten – Universität Innsbruck

Forschungsprojekte


ABCD
Tema (Topic) Status Betreuer (Mentor)
D1 Multi-level & Multi-cell Power Converters for LV Power Quality Applications Started in October 2019 Candidate: Zoran Miletić, AIT Univ.-Prof. Dr. Petar J. Grbović petar.grbovic@uibk.ac.at
D2 Partial Power Rated Converters for Ultra-Efficient/Dense Applications Started in October 2019 Candidate: Igor Lopušina, i-PEL
D3 High Power Battery Charger for e-Mobility Applications Started in October 2019 Candidate: Aleksandra Stanojević, i-PEL
D4 Power Supplies and Actuator-Converters for Future Robot Applications Started in April 2021 Candidate: Andreas J. Hanschek, i-PEL
D5 Integrated Actuator-Converter System for High Power Robot Applications Open
D6 High Power WBG Devices: Perspectives, Issues and Applications Open
D7 On-Line Monitoring and Diagnostic of High Power WBG Devices Open
D8 IGBT & MOSFET Gate Drivers: On-Chip Integration of Signal and Power Open
D9 Reverse Voltage Blocking Power Semiconductors: Perspectives, Issues and Applications Open
D10 Quantum-Mode Series Resonant Converters for High Frequency & High-Power Applications Open
D11 Multi-Cell Current-Source Converters: Analysis, Design and Application Perspectives Open
D12 Ultra-Dense Adapter & Charger for Cell-Phone and Lap Top Applications Open
D13 Ultra-Efficient & Dense 48 –to- 12V Automotive dc/dc Converters: Si & WBG Perspectives Open
D14 Ultra-Dense ac/dc Power Converters for Portable Equipment & Tools Open
D15 Analysis Design and Optimization of an Interface Power Converter for Energy Storage Grid Applications Open
D16 Modular MVDC Conversion System for 2MW Hybrid Micro Grid for 9km long Aerial Lift Open
D17 High-Power & Ultra High-Performance Multi-Phase Source & Load Emulator Open


ABCD
Tema (Topic) Status Betreuer (Mentor)
М1 Analysis & Design of an Automotive 48-to-12V dc/dc Converter To Start May 2020 Candidate: Univ.-Prof. Dr. Petar J. Grbović petar.grbovic@uibk.ac.at
М2 Development of a Single-Phase Half-Bridge Rectifier/Inverter with an Active DC Bus Capacitor
М3 Development of a Compact Military Grade 24 to 12V dc/dc Converter
М4 Failure Mode Analysis and Protection of a Three-Level NPC Converters
M5 Testing and Characterization of Cutting-Edge Power Semiconductors
M6 Analysis and Design of a Voltage Control Device for Low Voltage Distribution Transformers
M7 Topologies and Concepts of High-Power e-Mobility Chargers: An Overview and Comparative Analysis
M8 Development of an Active & Adjustable Dissipative AC Load Resistor
M9 Development of Power Supply and Drive Converter for Robot Applications
M10 Development of an Intelligent Control and Monitoring System for Agricultural Applications
M11 Development and Design of a Compact Power Supply for LED Applications
M12 Development and Design of a Power Converter for Grid Connected Permanent Magnet Synchro-Generators
M13 Development and Design of Battery Interface DC-DC Converter for Bipolar DC Microgrids
M14 Development and Design of Power Converter for Fish Protection in Hydro Power Plants


ABCD
Tema (Topic) Status Betreuer (Mentor)
B1 Smart Agriculture: Irrigation System with Hybrid PV/Wind/Battery Power Supply and GSM/GPRS Monitoring and Control Started in July 2019 Candidate: Tobias Pusnik Univ.-Prof. Dr. Petar J. Grbović petar.grbovic@uibk.ac.at
B2 Hydraulic-Drive Control Board Started in April 2020 Candidate: Lukas Messner
B3 Electric Fence for Fish Protection in Hydro Power Plants: Issues and Perspectives Started in April 2020 Candidate: Tim Florian Schellhammer
B4 Development of Low-Cost GSM/GPRS Sensor & Controller with PV & Battery Power Supply Started in April 2020 Candidate: Tim Hoschek
B5 Battery Management System for F1 prototype To Start May 2020 Candidate: Philipp Stocker
B6 Power Conversion Control Platform based 32-bit Arm® Cortex® Microcontroller (MCU) Families by Cypress-Infineon OPEN
B7 Induction Generators in Small Hydro Power Plants: Application Perspectives started March 2021 Candidate: Fabio Palanga
B8 Smart Home Power Supply System based on Renewable Resources & Electro-chemical Batteries OPEN
B9 Voltage Quality Control in LV Distribution Networks: Power Electronics Approach OPEN
B10 Analysis and High-Level Design of a Voltage Control Device for LV Distribution Transformers & Networks OPEN
B11 DC Power Distribution for LV Home Applications: Perspectives and Issues OPEN
B12 GSM/GPRS Modem for Remote Monitoring and Control OPEN
B13 Power Conversion Control Platform based on ARM Cortex MCU OPEN
B14 Development of Low-Cost GSM/GPRS Sensor & Controller with PV & Battery Power Supply OPEN
B15 Power Converters for Grid Connected Permanent Magnet Synchro-Generators OPEN
B16 High Performance Electric Machine Emulator: Issues and Perspectives OPEN
B17 Analysis and Comparison of Cooling Methods for State of the Art Switching Devices (Si, SiC, GaN) Cooling Devices PDF OPEN    Dr. Yann E. Bouvier  
B18 Analysis and Comparison of Cooling Methods for Magnetic Components for High Power Density Electronics Cooling Magnetics PDF  OPEN
B19 Design of a Magnetic Component Tester Equipment Magnetic Tester Equipment PDF  OPEN
B20 Multivariable objective optimization software developmentusing Pareto Front Analysis for power converters optimization Objective Optimization Software Development PDF OPEN
Nach oben scrollen